Usage instructions SPEEDY 4all & 4you & 4teen
45
Figure 121: Locking pin lever in a vertical position to
the footbar joint, opened
If the footrest should engage in the folded up
position, move the locking pin lever back to the
horizontal position to the footbar joint. The
locking pin levers are now not resting against
the footbar joints as the locking pins are not
engaged in the locking position yet.
Figure 122: Locking pin lever in horizontal position,
not engaged and thus not resting against the footbar
joint
As soon as an engaged position is reached
during the return movement, the locking pins
engage and the levers rest against the footbar
joint.
Figure 123: Locking pin lever in horizontal position,
engaged and thus resting against the footbar joint
If you want to move the footrest back into the
standard position, perform the as previously
described and during this process, move the
footrest to the front.
After "folding up to the back" each time, make
sure that the footrest has engaged correctly
again. This is visible when the locking pin lever
rests against the footbar joints (Fig. 123).
To
adjust the length of the footrest support
tubes
or adapt the lower leg length
, the M6
fixing screws (AF 4 mm) on the front sides of
the frame tubes must be released on both
sides. Fix the footrest support tubes to the
inlets using the M6 fixing screws (AF 4 mm)
that have 3 holes that serve the setting of the
lower leg length. Only an extension of the low-
er leg length is possible as the footrest support
tube is always fixed in the top hole of the inlet.
Locking pin
lever in a
vertical
position
Fold-up to
the back
Locking pin
lever in hori-
zontal posi-
tion, not en-
gaged
Locking pin
lever in
horizontal
position,
engaged
Footbar joint
