Usage instructions SPEEDY 4all & 4you & 4teen
44
When you fold the footrest back down, take
care that the recesses are resting accurately at
the back and front on the cylinder pins of the
bracket.
Figure 118: Cylinder pin and corresponding recess-
es
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 10 mm) must
be undone on both sides on the outside of the
frame tube. The footrest support tubes are
then pushed along their slots and thus brought
into the correct position. Observe that the foot-
rest support tubes are both the same length on
both sides after they have been adjusted.
Figure 119: M6 fixing screw with washer and slot in
footrest support tube for adjusting the lower leg
length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 10 mm) with washers to 7 Nm on
both sides.
Note:
With a V-shaped product frame or with a larger
lower leg width at the top than the bottom, it is
necessary to relieve the footrest support tube
tension in the footrest support plate resulting
from longitudinal adjustment or to correct the
shifted position of the footplate support. The
footplate support can be moved back to the
correct position by opening the M6 fastening
clamp screws (AF 5 mm) on the footrest sup-
port plate. View the procedure in Chapter 23.1.
23.4 Footrest, fold up to the rear
Figure 120: Footrest, fold up to the rear, in standard
position
To
fold up the footrest to the rear
, move the
locking pin lever on the right and left side to the
vertical position to the footbar joints. Now you
can move the footrests to the rear.
Bracket with
cylinder pin
Recesses
M6 fixing
screw
with
washer
Slots in the
support tube
