Usage instructions SPEEDY 4all & 4you & 4teen
49
Figure 134: Moving locking pin lever perpendicular
to remove swing away footrest
Figure 135: Swing away footrest removed
To
adjust the length of the footrest support
tubes or adapt the lower leg length
, the M6
fixing screws (AF 4 mm)
must be released on
both sides. The footrest support tubes are then
pushed along their slots and thus brought into
the correct position. Observe that the footrest
support tubes are both the same length on
both sides after they have been adjusted.
Figure 136: M6 fixing screw with washer to adjust
the lower leg length
Once the position has been set, fix the footrest
support tubes by tightening the M6 fixing
screws (AF 4 mm) with washers to 11 Nm on
both sides.
23.8 Safety instructions
Ensure when setting the lower leg length,
that no strong pressure is produced between
the underneath of the lower leg of the wheel-
chair user and the edge of the seating system.
24 Anti-tipping support
To minimise the risk of tipping backwards unin-
tentionally, anti-tipping supports are available
as accessories. The anti-tipping supports are
adapted to the axle tube via anti-tipping sup-
port adapters and can be swivelled under the
frame using a spring system.
M6 fixing screw
with washer
Move the locking pin lever
perpendicular to the bracket
Locking pin lever
