Primera LP130e, Руководство пользователя

Страница: 14 / 50

10
Label Stock
Note: See table on next page for Max and Min values in inches and mm.
Max Min
Label Width 5.0" (127 mm) 0.75" (19 mm)
Liner Width 5." (127 mm) 1.5" (38.1 mm)
Label Height/Length 12" (305 mm) 0.75" (19 mm)
Core Width 5.125" (130 mm) 5.125" (130 mm)
Gap between labels 10" (253 mm) 0.1" (2.5 mm)
Width of Thru-Hole 2" (50.8 mm) 0.6" (15.2 mm)
Distance from Edge of Liner to Edge of
Thru-Hole
0.9" (22.9 mm) 0.5" (12.7 mm)
Reflective Sensing/Black Mark Width* N/A 0.1" (2.5 mm)
Max Outer Diameter (OD) 6.0" (152.4 mm) N/A
Inner Core Diameter (ID) 3.0" (76.2 mm) 3.0" (76.2 mm)
Total Thickness
(Liner + Label)**
0.0075” (7.5 mil) N/A
Distance from Edge of Media to Edge of
Label
Printer driver assumes .063" (1.6
mm) gap.
However, this is
adjustable
via the Left Margin
Offset setting.
* The black mark should be opaque to infrared light. The mark should
be between the labels. The end of the mark should correspond with the
beginning of the label.
**There are two factors that determine whether the printer will accept
any particular stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the liner if the sensor is
set to die-cut.
If you are printing in continuous or reflective label sensing mode,
Number 2 does not apply. The fact that the printer must read through
the backing in die-cut mode will limit the thickness much more than the
printer's ability to pull the paper through the print area. However, if
you adjust the opacity level of the liner enough to allow the label to be
seen by the stock sensor, the thickness will only be limited by the
printer's ability to pull it through the print area. For these reasons the
weight or thickness of the liner is a variable that cannot easily be
recommended.