
MG14 operating manual Rev 1.4
16
3.3 Connecting
3.3.1 Back Side of the Device
Fig. 3-4, shows the back side of the MG14.
Fig. 3-4 Back side of the MG14
A
Connection for IONIVAC measuring signal, channel 1
B
Ground screw
C
Connection for transmitter, channel 1
D
Connection for transmitter, channel 2
E
RELAY connection
F
AnybusCC connection module
G
Mains connection
H
I/O interface
DANGER
!
Screw for internal protective conductor.
The internal protective conductor is connected to the casing with a screw.
Do not turn or loosen this screw.
The configuration of the available connections is described in the following sections.
3.3.2 Mains Connection
The mains connection (Fig. 3-4, item G) is designed for a mains cable which contains a European
appliance connector on the device side. A mains cable is supplied with the device. If the plug is not
compatible with your wall socket, you have to get a suitable mains cable:
Three-conductor cable with protective ground
Conductor cross-section 3x1.5 mm
2
or larger