
MG14 operating manual Rev 1.4
15
NOTE:
Please carefully insert the module in
– parallel to the PCB board – please refer to the Fig.3.2.
Fig. 3.2 Installation of an interface module
To be sure if the module is mounted correctly please have a look into the unit via the holes as shown
on the photo Fig. 3.3
Fig. 3.3 Anybus Module mounting
1. When inserting the module into the slot, press it with its plain side onto the MG14 board.
2. Tighten the affixing screws until they make contact with the panel
– ref..
3. The affixing screws lock the module in place in the slot.