UNI-PDS/UNI-EPDS
Page 8
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Please review the Operator’s Manual that came packaged with your projector before attaching the upper
mounting bracket. The correct throw distance (the distance from the projector to the screen) must be
determined prior to mounting the projector.
n
n
Refer to the projectors Users Manual to determine the
distance from the lens to the front of the screen (X).
n
o
Measure the distance from the front of
the lens to the center of the projector
(Y).
n
p
Measure the distance from the wall
to
the face of the
whiteboard/screen (Z).
n
q
Add all measurements (X + Y + Z) to
determine projector placement on the arm assembly. This
measurement will determine where the center of the mount
bracket will be located on the arm assembly. Please make
note of this measurement.
Front Lens
Rear Lens
Calculations
X = Manufacturers recommended
throw distance
Z = Distance from wall to face of
whiteboard/screen
Front Lens Throw Distance =
(X + Y + Z)
Rear Lens Throw Distance =
(X - Y + Z)
Throw Distance Calculation
The UNI-PDS/UNI-EPDS can be also used as
a wall-mounted standard projector mount as
well as a short throw projector mount. Align
the projector facing the opposite direction
from the wall plate to project the image
across the room. Please take into account
the projectors throw capabilities prior to
mounting in the projector opposite direction
n
q
Locate the two (2) lock mounting points on the projector arm. These two
points will be aligned with the lock mounting points on the wall plate.
n
r
Using a security wrench, insert and tighten two (2)
M5 x 8mm security head screws.
Do NOT overtighten these screws.
Step 2
Lock Mounting
Point
M5 x 8mm Security
Head Screw
Security Wrench
Proceed to the
“Throw Distance
Calculation”
section.
Proceed to the
“Adjustable Mounting Bracket
Installation”
section.
