UNI-PDS/UNI-EPDS
Page 14
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Attaching the Universal Projector Plate (cont’d)
Step 3
Raise or lower each of the mounting legs, by rotating the leveling barrels, until all
of the mounting legs are at an equal height.
•
Lower the mounting leg by rotating the leveling
barrel counter-clockwise.
•
Raise the mounting legs by rotating the leveling
barrel clockwise.
n
n
Identify the projector’s approximate front-to-back center of gravity. Place
your hands on each side of the projector and gently lift it an inch from the
surface on which it is resting. Carefully adjust your grip on the projector until
it seems balanced from front-to-back. Mentally note the apparent center of
gravity.
n
o
Identify the projector’s approximate side-to-side center of gravity. Place your
hands on the front and back of the projector and gently lift it an inch from the
surface on which it is resting. Carefully adjust your grip on the projector until
it seems balanced from side-to-side. Mentally note the apparent center of
gravity.
n
p
Place the
Universal Projector Plate on top of the mounting legs with the
center hole as close as possible to the projector’s center of gravity.
Step 4
Step 5
n
n
Verify that the mounting legs are at an equal height. Return to
Step 3
if
they are not at an equal height or the Universal Projector Plate is not level.
n
o
Verify the position of the integrated sliding M6 square nut in the mounting leg
relative to a nearby slot on the Universal Projector Plate.
If the M6 square nut is not aligned with any slot, you can use any thin
implement, such as a toothpick, to nudge it into alignment.
Side-to-Side
Center of Gravity
Front-to-Back
Center of Gravity
Sliding M6
Square Nut
