UNI-PDS/UNI-EPDS
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 5
n
n
Measure distance from center of lens to the top of the PDS-PLUS bracket (C).
n
o
Add the distance from the ground to the top of the screen (A). Add the projector manufacturers recommended
offset from the projector manual (B). Add the measurement from Step 1 (C), and then add 2.5˝ to the total.
(Example: A + B + C + 2.5˝ = ?)
n
p
Add the measurements to determine the mounting height mark. Place a mark at the top of the total calculated height measurement starting from the ground up.
This mark will represent the lower edge of the wall plate.
Refer to the projectors User’s Manual to determine the offset of the projector lens to the top of the
screen/whiteboard (B).
Lens
PDS-PLUS Bracket
Projector
In order to determine the installation height and throw distance, the PDS-PLUS projector bracket must be mounted
to the projector. Please refer to the PDS-PLUS Installation Instructions prior to performing the following steps.
Top of Screen
Mark
Legend
A -
Distance from ground to the top of the
screen/whiteboard (viewable area).
B -
Manufacturers recommended offset
measurement. This measurement will
be listed in the Users Manual.
C -
Center of the lens to the top of the
projector bracket.
Add 2.5˝ to the calculated total.
This total distance will be the location for the bottom rail on
the wall plate.
Proceed to the
“Wood Stud Installation”
section.
Ground
Determining the Installation Height
