UNI-PDS/UNI-EPDS
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 13
Multiple Mount Point Installation
Step 1
n
n
Locate the projector’s mount points.
n
o
Position an appropriate number of mounting legs on the projector.
You can use any combination of three (3) or more long mounting legs and short
mounting legs, depending on the number and location of the thread inserts on
your projector.
The number and placement of mount points on projectors varies
between projector manufacturers. This example projector has five (5)
mount points, but only uses four (4) mounting legs.
Step 2
Insert the mounting hardware, as determined in the
“Selecting the Mounting
Hardware”
section, through the leveling barrel into the thread insert of the
projector.
You can use either the standard Phillips head or Lock-It™ security
hardware.
Do not tighten the mounting hardware at this time.
Attaching the Universal Projector Plate (cont’d)
Mounting Hardware Too Long?
The depth of some projector mount points may prevent you from
tightening the M2.5 and M3 mounting hardware.
You can reduce the length of the M2.5 and M3 mounting hardware
by stacking up to a maximum of five (5) M3 flat washers inside the
leveling barrel.
Avoid stacking too many M3 washers; the mounting hardware must
thread into the projector mount point at least four (4) complete
turns.
