UNI-PDS/UNI-EPDS
Page 16
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Attaching the Projector
n
s
Insert the four (4) M6 x 12mm tilt adjustment screws, two (2) per side.
You can use either the standard hardware or Lock-It™ security hardware.
n
t
Tighten all screws.
Do not overtighten the mounting screws.
n
u
Follow the PDS Installation Instructions to complete the installation.
n
n
Place one (1) nylon washer and one (1) ¼″ flat washer over the hinge pin.
n
o
Insert and tighten one (1) M6 x 12mm screw.
n
p
Repeat 1 and 2 for the opposite hinge pin.
You can use either the standard hardware or Lock-It™ security hardware.
Replace eight (8) M6 x 12mm screws and one (1) M6 x 8mm set screw.
Do not overtighten the M6 x 12mm screws or the M6 x 8mm set screw.
n
q
Slide the projector / Projector Plate assembly onto the PDS Base Box.
n
r
Hook the Projector Plate over the hinge pins, as shown.
Base Box Adjustment
n
n
You can adjust the roll of the projector by loosening the three (3) front and
rear M6 x 12mm screws.
Do not fully loosen the screws, as the mount may drop.
n
o
Set the desired roll and then tighten the screws. First tighten the center
screws and work your way to the outside screws, making any final
adjustments prior to tightening the last two screws.
n
p
You can adjust the tilt of the projector by loosening the two (2) M6 x 12mm
screws on each side of the Base Box.
n
q
Set the desired tilt and then tighten the screws, making any final adjustments
prior to tightening the last two screws.
If your projector is not holding the tilt, install the four (4) external tooth
washers on the four (4) M6 x 12mm Phillips head screws w/ Integrated
Washers.
n
r
Once all adjustments have been made, tighten all hardware.
