UNI-PDS/UNI-EPDS
Page 10
Visit the Premier Mounts website at http://www.mounts.com Installation Instructions
n
n
Raise the base box to the upper mounting bracket.
n
o
Align the two (2; one each side) mounting holes.
n
p
Using a security wrench, insert and tighten two (2) M6 x 12mm security
head screws.
n
q
Attach the projector to the base box, referring to the PDS-PLUS
installation instructions for final adjustments.
Attaching the Base Box to the Adjustable Mounting Bracket
The M6 x 12mm security head screws must be
mounted from the underside of the base box.
Base Box
M6 x 12mm Screws
Security Wrench
Adjustable Mounting
Bracket
n
n
Slide the extension arm into the open end of the UNI-STA (the front of the
mount).
n
o
Adjust length so that the center of the adjustable mounting bracket
matches the throw distance calibration.
n
p
Line up the mounting holes on the extension arm with the mounting slots
on the UNI-STA.
n
q
Using a screwdriver, insert and tighten two (2)
M6 x 12mm security head screws and
M6 flat washers through
the
external slide plate and tighten.
n
r
Attach the projector.
Please refer to
Attaching the Base Box to the
Adjustable Mounting Bracket
(above) for steps on
attaching the projector.
M6 x 12
Security
Screw
Security Wrench
M6 Flat
Washers
Adjustable
Mounting
Bracket
UNI-STA
If the extension arm is purchased at a later date, the end cover must be removed prior to installing the extension
arm.
Please see the Operator’s Manual to determine the correct throw distance (the distance from the projector to the
screen). The throw distance must be determined prior to mounting the projector (Page 8).
Extension Arm
(Optional)
Extension Arm Installation (Optional)
External Slide
Plate
Do NOT overtighten these screws.
Proceed to the
“Low Profile Bracket Installation”
section.
