- 37 -
0100-GB WARTUNG_8531
MAinTEnAnCE
GB
83
1
81
Inspection of Gates:
Before commencing sowing and with empty hopper, use the adjusting
gauge (
71/H1
) to check the settings of all the gates; set the gate
control lever (
81/H
) to „
1
“ and turn the sowing shaft until the groove
points downwards.
Slide the adjusting gauge between the sowing roller and the gate
beside the middle row of sowing roller cams and turn from top to
bottom until the handle rests on the sowing box.
The adjusting gauge must „fit“ without any play; slacken the screws
to make any readjustments (
81/H2
) and then retighten in the correct
position ensuring there is no play.
Setting of Sensors:
The sensors are spaced 1- mm apart (Fig.
82
).
An operation control (LED) has been integrated into the sensor,
giving a visible indication of whether the sensor is working during
corrective adjustments or test runs. (See also section Sensor Testing
- Operating Instructions for Multitronic appendix A).
Removal of Sowing Shaft:
Open the shutter and - after loosening and moving the ring (
83/1
)
-rotate the shaft in such a way that the clutch (on the right) is more
or less horizontal.
Turn the bearings (
83/2
) to the right (90°; press ratchet) and slide
to one side.
Remove the shaft from the rear. (Follow the instructions in reverse
order to mount the shaft: replace the bearings and rotate 90° to the
left. Lock the ring (
83/1
) in place „over“ the clutch. Ensure that „side
play“ of the sowing shaft is restricted by a limiter screw (
26/3
, page
12). Adjust as necessary.
when performing welding work on the tractor or an attached
machine and when charging the tractor battery or connecting
a second battery (jump start) always disconnect from the
electronics box.
82
