0800-GB VITASEM Multitronic
-
A
2 -
MULTiTrOniC ViTASEM
GB
Quick guide Multitronic II VITASEM
Default settings
Sensor test Calibration assistence
4.4 Main menu
Press the F function key to activate the main menu. The seed drill unit is now running with its default settings <AdJU>. This operation also
activates the system utility functions sensor test <SEns> and calibration assistance <CAL>.
/
3 Sek.
3 Sek.
3 Sek.
3 Sek.
3 Sek.
3 Sek.
/
/
/
/
/
/
1 2 3 4
1 = Sowing shaft monitoring
2 = Hectare meter
= Tramline cycle relaying
4 = Hopper level monitoring
Use arrow keys to select
and save working width
Use arrow keys to select
and save driving lanes
rhythm
Adjustment is carried out in the field
Do not carryout gauging: briefly press
F-key
Use arrow keys to select
and save the number of
wheel impulses
Use arrow keys to activate
(On) or deactivate (Off)
and save the sowing shaft
monitor
Use arrow keys to activate
(On) or deactivate (Off)
and save the hopper level
monitor
Use arrow keys to select
and save the delay time
W i t h F - k e y,
back to the main
menu
/
W i t h F - k e y,
back to the main
menu
W i t h F - k e y,
back to the main
menu
/
Onboard voltage display:
z.B.: 12.0 Volt
Use arrow keys to select
and save the calibrating
areas:
(10 = 1/10 ha)
(20 = 1/20 ha)
(40 = 1/40 ha)
(100 = 1/100 ha)
Alarm functions / messages
Sowing shaft monitoring alarm
Hopper level monitoring alarm
Leaving the main menu:
You can exit the main menu at any time by pressing one
of the four display pushbuttons.
To save settings:
Keep the F key pressed for 6 sec. The display will start
flashing after 2.5 sec. An acoustic signal will sound after
6 sec. When the sound stops, the setting is saved. The F
key can be released. If the F key is released any earlier,
the old setting will be retained.
6 Sek.
