GB
ATTACHING TO THE TRACTOR
- 7 -
0400-GB Anbau_243
Preparations for initial operation
Important!
1. The working position means that implement is lowe-
red and rotor tines are lightly touching the ground
(A1)
2. The distance (X) between drive shaft and linkage
drawbar should be at least 120 mm when in working
position (standard). Take note of distance ”X” parti-
cularly when travelling over humps.
3. The position of rotor tines should be roughly parallel
to the ground. A slight inclination forward is allowed.
4. Set distance (X1) using thresded spindle
For machines with the ”MULTITAST” system, set a shaft swivel
range here which enables rotor tines (A1) to adapt well to
gound in uneven areas.
- see chapter ”THE ”MULTITAST” SYSTEM” also.
Distance (X) adjustment
(up to 2003 model)
1. Attach machine to tractor and bring to working position (see
above).
2. Remove linch pin (V).
3. Swing lever (H) up (90°)
4. Turn threaded spindle accordingly.
MULTITAST system (Optional extra)
- see chapter ”THE ”MULTITAST” SYSTEM” also
For machines without ”MULTITAST”
- turn threaded spindle until it stops
(X1 =0 mm)
For machines with ”MULTITAST”
- turn threaded spindle to a distance of
X1 = 30 – 50 mm.
5. Swing lever (H) down (0°) and secure with linch pin (V).
In this position the threaded spindle is secured against turning.
