GB
ATTACHING TO THE TRACTOR
- 5 -
0400-GB Anbau_243
A
E
TD 26/92/16
s
h
0
ST
DW
DW
EW
TD44/94/1
Hydraulic connection
There must be at least one double action and one single action hydraulic
connection available on the tractor.
Connecting hydraulic system to the tractor
- Only connect hydraulic system to the tractor when stopcock is closed
(position A).
EW
Connect the plug-in connection with the ”red” dust cap to the single
action control valve.
DW
Connect both plug-in connections with the ”blue” dust caps to the
double action control valve.
Lowering the machine
The machine can be lowered both from the working position and from
the transport position.
- Park machine stabily!
- Secure implement from rolling using wheel chocks!
- Swing support stand down (5a) , secure with locking pin
(B)
- Pull off drive shaft and rest on support.
Do not rest drive shaft on safety chain!
- Close stopcock on every connector (pos. A) and then disconnect hydraulic
lines from tractor.
Should problems occur when disconnecting:
- Move servo-valve (ST) briefly to "lower" position (s).
Doing this will reduce any possible pressure remaining in the connector
and allows a trouble-free disconnection of the hydraulic lines.
- Disconnect appliance from tractor.
Shorten total length (80 cm)
- by swinging the forward rotor unit inward
