GB
ATTACHING TO THE TRACTOR
- 6 -
0400-GB Anbau_243
Initial attachment to tractor
Safety hints:
see supplement-A1 points 7.) 8a. - 8h.)
Procedure:
1. Attach shaft to tractor´s linkage drawbar
Important!
The tractor linkage drawbar must be movable (A-B)
- Left and right lifting struts (4) must be of equal length.
2. Secure fixing bolts using linch pin (V).
3. Fix the hydraulic lower link (5) in such a way that the
machine cannot swing out sideways.
4. Raise jackstand (10) and secure with bolt.
5. Set tractor hydraulic at correct height (H).
Ensure sufficient distance to drive shaft (X) particularly
when travelling over humps.
6. Connecting hydraulic line to tractor.
- Stopcock closed (position A)
- Connect hydraulic line (60) to tractor.
7. Lowering implement
- Stopcock opened (position E)
- Engage servo-valve (ST).
Implement is lowered slowly to the ground.
Drive shaft
Before operation, check lengths of drive shafts and adapt if ne-
cessary (see chapter "Adaption of Drive Shaft" in supplement B
also).
Important!
Always connect wide angle joint to tractor, not
to machine!
