Porsche 911 GT3 Cup 2018, Техническое руководство

Страница: 117 / 477

Version: 4/20/2018
6
116
Powertrain
911 GT3 Cup (991 II)
MY 2018
2.9.5 Pinion shaft
Hot components
Danger of burns

Wear personal protective equipment.
Heat the interior of the cylinder roll bearing at 130
°
C (266 F) for 20 minutes
Press the inner ring on the pinion shaft up to the limit (Figure 2.9.5.1)
Insert the base adjusting disk (1) (2.00 mm P1) (Figure 2.9.5.1)
Put on the bottom inner ring of the four-point bearing
Insert the pinion shaft through the gearbox housing
Put on the top inner ring of the four-point bearing
Put on mounting ring no. 25 (reverse gear replacement)
The mounting ring no. 25 in this case only serves as a
substitute and is replaced with the reverse gear wheel
(spur gear) during final assembly (2.9.7 Assembly of
gear sets).
Put on the three guide sleeves (1), the position of the sleeves is not relevant here
(Figure 2.9.5.2)
Use tool no. 27 (counter torque wrench) for the outer guide sleeve
Lubricate the inner ring of the pinion shaft (1) well and put it on (Figure 2.9.5.3)
Lubricate the pinion shaft nut well and put it on loosely (do not tighten yet)
2.9.5.3
2.9.5.1
2.9.5.2
Caution
Information