20
TECHNICAL SUPPORT: (909) 259-6001
BLSW1016
Installation: LIMIT SWITCH SET-UP
Limit Switch Set-Up:
STEP 8
Install the Cover by carefully
slipping the front half over the Limit
Switches and Cam Wheel., then fitting the
back cover in place. Latch the hasps on both
sides of the Cover.
STEP 7
A. Loosen the screws on the Limit Switch Cams.
B. Remount the articulated arm, making sure
the cam wheel pin is engaged with the
clutch.
C. Move the gate manually to the closed position.
D. Move the Limit Switch Cams on the Cam
Wheel to actuate each limit switch.
E. Slightly tighten the screw on the Limit
Switch Cam.
F. Move the gate manually to the open
position. Repeat steps a, b and c for the
other cam.
G. Run the unit 2 full cycles without
interruption (from limit to limit) to
execute a “Learn Cycle.”
Gate Opens to Right
Left Limit Switch
Open limit
Right Limit Switch
Close limit
Gate Opens to Left
Left Limit Switch
Close limit
Right Limit Switch
Open limit
Left Limit Switch
Right
Limit
Switch
Limit Ring
Limit Switch Cam
Cam Wheel
Set Left Cam
In This Direction
Set Right Cam
In This Direction
BLSW1016 Manual_Layout 1 5/8/2015 5:06 PM Page 20
