18
TECHNICAL SUPPORT: (909) 259-6001
BLSW1016
Installation: ElecTrical
- (Green)
Earth Ground (Green/Yellow)
+ (White)
Hot (Black)
Neutral (White)
To Power Harness
power cable to the board. USE MIN. 14 AWG WIRE. FOLLOW ALL LOCAL ELECTRICAL CODES.
Power Harness
White
Green
Red
Black
To help protect the equipment from lightning and power
surges and to protect persons from shock hazard the
Operator must be grounded. The earth ground rod
must be located within 3 feet from the gate operator.
Use the proper type earth ground rod for your local
area. The ground wire must be a single, whole piece of
wire. Never splice two wires for the ground wire. If you
cut the ground wire too short, break it, or destroy
its integrity, replace it with a single wire length.
Prevent unnecessary turns or loops in ground wires.
The gate operator and the battery charger require a
single phase AC line to operate.
1. Turn off the breaker for the circuit you are using.
2. Select the proper voltage on the power board.
3. Connect the incoming power wires to the proper
terminals.
4. Turn on the breaker and check that AC ON and
CHARGE LED are lit.
Ground Rod
Earth Ground
The power receptacle has been left unconnected till the installer decides what voltage to use.
Connect to 120VAC only
BLSW1016 Manual_Layout 1 5/8/2015 5:06 PM Page 18
