Planika MONROE 900 F, Руководство по установке

Страница: 58 / 68

Copyright Planika Sp. z o.o. www.planikafires.com IG0139#02 30.07.2018 58
7.3.2. The Hearth

Ignition electrode should light the central hearth within few seconds and without explosively.

Flame in the middle hearth must smoothly and without the explosively pass through the burner and
must burn continuously.

The side sections of the hearth should fire off immediately after the activation of the second valve, and
the transfer of the flame on the side sections must be smooth and without explosively.

If there is no ignition of the device after three restarts, the permanent lock the device is activated and
it may be impossible to reset by disconnecting the power supply. If you still need to restart, remove
the glass and make sure that nothing is blocking the free flow of gas to the burner. Then, the device
can be disconnected from the power source for 10 seconds. After these 10 seconds the power supply
can be reconnected. It should light up the device in the same way as in the case of the first ignition,
according to the information contained in Section 7.3.1.

Check the operation of the burner from a cold state.

If the sparks are detected between the electrodes, the central hearth should ignite within a few
seconds.

The image of the flame and the correct transfer of the flame to the side sections of the burner can be
evaluated properly only when the front glass is mounted.

If the ignition of the main burner does not correspond to the above requirements, refer to the table of
error messages to determine the cause.
7.4.
Flame
WARNING!!! The image of the flame depends on the type of gas used. Different types of propane and butane
gas mixtures, as well as various types of natural gas, can cause a change of the color and appearance of the
flame, smoke or even soot effect on the decorative elements (ceramic logs and pebbles).
An image of the flame can be effectively evaluated after the first few hours of use. The image of the flame is
affected by the volatile components of paint, materials, etc., which evaporate during the first hours of the
fireplace use.

Make sure that the image of the flame on the hearth is correct.

If the image of the flame is not acceptable, use the table of error messages to solve the problem.