Planika MONROE 900 F, Руководство по установке

Страница: 62 / 68

Copyright Planika Sp. z o.o. www.planikafires.com IG0139#02 30.07.2018 62
11. TROUBLESHOOTING
Warning! Installation, repair and maintenance must be performed only by a trained engineer with the
appropriate permissions, service company or gas supplier.
There are many factors that may affect the malfunction of the gas insert. To exclude a possible fault in the
unit or the automatic gas control system, make sure that the fireplace is connected according to these
instructions.
Below table summarizes possible failures that may occur, possible causes and ways to solve them.
ERROR
CODE
FAULT POSSIBLE CAUSE REPAIR
SMELL OF GAS IMMEDIATELY CLOSE THE GAS VALVE ON THE GAS CONNECTION. DO
NOT USE THE APPLIANCE UNTIL SPILLS ARE FULLY REMOVED
F00 Flame not detected in time and
the burner control doesn’t
report a failure.
F01, F07 or F08 appeared 3 times Device blocked. Wait 30 minutes before trying
again.
No spark Make sure that the distance between the
electrodes is 3-4 mm
No Gas Make sure, there is a gas connection
F01 The lack of communication
between the receiver and the
automation controller
Communication cable does not make
any contact Make sure that the contacts of the communication
cable ensure correct contact
Damage to the communication cable Replace the communication cable
F02 Overheating of the receiver (60 °
c above room temperature) Poor ventilation by the receiver Improve ventilation at the receiver
The receiver is in contact with the hot
parts Move the receiver so that it does not touch the
hot parts
F03 Internal NTC sensor( of the
receiver) is not working properly
Damaged receiver Replace Receiver
F04 External NTC sensor is not
working properly
External NTC sensor or wiring are
damaged
Replace the NTC sensor or wiring
F05 Internal security error Damaged receiver Replace Receiver
F06 Lack of communication between
the transmitter and receiver The transmitter is out of range of the
receiver Make sure that the transmitter is located near the
receiver
Any obstacles between the transmitter
and the receiver may interfere with the
signal
Remove any obstacles between the transmitter
and receiver
Power transmission is too weak Check the power transmission (see. Instruction
Manual Chapter 9)
F07 Flame not detected in time and
the burner control doesn’t
report a failure.
No spark Make sure that the distance between the
electrodes is 3-4 mm
No Gas Make sure, there is a gas connection
F08 No ionisation / The burner
control reports a failure and the
flame could not be detected in
time.
No spark Make sure that the distance between the
electrodes is 3-4 mm
Replace the ignition electrodes
Check if the cables for the ignition electrode are
connected correctly
No Gas Make sure, there is a gas connection