Planika MONROE 900 F, Руководство по установке

Страница: 55 / 68

Copyright Planika Sp. z o.o. www.planikafires.com IG0139#02 30.07.2018 55
6.2.2. The wireless connection through the protocol "Modbus"
Wireless connection of home automation system with the receiver can be established via compatible protocol
"Modbus". This type of connection can be established only by using the communication module (Picture 20
"M"). This module can be ordered from Planika. This module converts the communication protocol "Modbus"
from home automation system for the wireless signal to the receiver.
Picture 20 - Schematic diagram of the electronics
If you connect home automation system to the receiver using a communication module, do the following:

Using the remote control, check whether the place where you want to place a communications module
is within range of the receiver.

Place the remote control in the right place and test the sensitivity of the received signal (RSSI). To do
this, simultaneously press the On/Off button and the arrow down button. The displayed value must be
between -20 to -80 (see. User Manual "Quality of Signal"). If necessary, place the remote control closer
the device in order to improve reception.

Connect the communication module using the RJ45 plug to the router in accordance with the
instructions contained in the manual supplied with this module.

Then follow the steps described in the manual protocol "Modbus". This instruction can be obtained
from the supplier of home automation system.