Planika MONROE 900 F, Руководство по установке

Страница: 7 / 68

Copyright Planika Sp. z o.o. www.planikafires.com IG0139#02 30.07.2018 7

In case of feeling any gas leaks, immediately turn off the fireplace and, depending on the type of fuel,
close the main valve on the gas cylinders LPG or close the valve supplying natural gas to the device.
You should also ventilate the room in which the fireplace is installed and contact the service staff.

If the unit is not used for a long time, depending on the type of fuel, close the main valve on the LPG
cylinder or close the valve supplying natural gas to the device.
3.1.
Safety instructions for MONROE’s fireplace instalation

MONROE fireplaces are not standalone devices and are intended only for installation.

You should install the ventilation grille or make a ventilation gap in the ventilation surface at least
300cm2 at the base of the installation to provide adequate circulation in its interior. The device without
grating or the ventilation slot on the desired surface will not work properly, creating a danger of
overheating and damage to the appliance, or in extreme cases of fire.

For installation of air combustion wires, you should only use the concentric system supplied by the
company Planika.

For the construction of fireplace housing equipment use only non-flammable materials (e. g. non-
combustible and heat-resistant plates or materials made of stone). Non-combustible materials must
be used to complete both external as well as internal part of the housing, and for completing the wall,
at which the device will be placed.

Strictly follow the minimum distance between non-combustible walls of the housing and the device.

To improve the circulation inside the unit and to reduce the risk of overheating of its walls (including
the wall, which the device was placed on), you must comply with the distances shown in the mounting
drawings.

Use the electric wires in high-temperature insulation, and place them away from the hot parts of the
fireplace and installation items.

Do not apply any additional insulation (wool, non-woven materials) do not wrap the device in any other
material.

Combustible materials should be placed no closer than within 1 m from the unit.

Only decorative accessories attached to the device by the manufacturer should be placed on the hearth
(logs, stones, vermiculite or ash imitation). These accessories should be installed as described in this
manual. Incorrect placement of decorative materials may result in shortening the useful life of the
hearth and its damage.

WARNING! Make sure you don’t place any decorative elements around the ignition and ionization
electrodes.