Planet IGS-10020, Руководство пользователя

Страница: 296 / 409

User’s Manual
296
•
Limit
The maximum number of MAC addresses that can be secured on this port. This
number cannot exceed 1024. If the limit is exceeded, the corresponding action is
taken.
The switch is "born" with a total number of MAC addresses from which all ports
draw whenever a new MAC address is seen on a Port Security-enabled port.
Since all ports draw from the same pool, it may happen that a configured
maximum cannot be granted, if the remaining ports have already used all
available MAC addresses.
•
Action
If Limit is reached, the switch can take one of the following actions:

None
: Do not allow more than Limit MAC addresses on the port, but take no
further action.

Trap
: If Limit + 1 MAC addresses is seen on the port, send an SNMP trap. If
Aging is disabled, only one SNMP trap will be sent, but with Aging enabled,
new SNMP traps will be sent every time the limit gets exceeded.

Shutdown
: If Limit + 1 MAC addresses is seen on the port, shut down the
port. This implies that all secured MAC addresses will be removed from the
port, and no new will be learned. Even if the link is physically disconnected
and reconnected on the port (by disconnecting the cable), the port will
remain shut down. There are three ways to
re-open
the port:
1) Boot the stack or elect a new master the switch,
2) Disable and re-enable Limit Control on the port or the switch,
3) Click the Reopen button.

Trap & Shutdown
: If Limit + 1 MAC addresses is seen on the port, both the
"Trap" and the "Shutdown" actions described above will be taken.
•
State
This column shows the current state of the port as seen from the Limit Control's
point of view. The state takes one of four values:

Disabled
: Limit Control is either globally disabled or disabled on the port.

Ready
: The limit is not yet reached. This can be shown for all actions.

Limit Reached
: Indicates that the limit is reached on this port. This state can
only be shown if Action is set to
None
or
Trap
.

Shutdown
: Indicates that the port is shut down by the Limit Control module.
This state can only be shown if Action is set to
Shutdown
or
Trap &
Shutdown
.