Planar Dome Md2/PCI, Руководство по установке

Страница: 82 / 116

68 | Installing the Board and Driver in a Sun PCI Workstation
Preparing for Board Installation
Before you install the board, read this section carefully. Also
review the installation requirements for the PC before you
proceed with board installation.
Unpacking the board
Remove the Md2/PCI board slowly from its package and static-
shielding bag to protect it against electrostatic discharge.
Disabling VGA mode
The Md2/PCI board cannot operate as a VGA board in a Sun PCI
workstation. Therefore, you must disable jumper J4, which is
used to enable or disable VGA mode on the Md2/PCI board. To
do so, make sure the shunt from jumper J4 covers only one pin, or
remove the shunt entirely.
Static electricity can damage the board. When touching the
board or parts of the motherboard, take these precautions:
• Wear an antistatic wrist strap.
• Always keep one hand touching a metal surface to
provide grounding.
• If you can’t perform a step with one hand, use both and
return one hand occasionally to the bare metal surface.
The shunt on jumper J5 must be on pins 1 and 2.