PRG AV4202N
© (2007) Pirelli Broadband Solutions S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
14
OGU 930500275-A1
Hardware Installation
1.
Connect one end of the Ethernet cable into one of the four Ethernet ports on
the rear of the Router
2.
Connect the other end of the Ethernet cable into the Ethernet Network card
of your computer
3.
Verify if the Ethernet Network card is configured as DHCP client, otherwise
configure it to remain in the same local network of the router interface (see
chapter “Setting Up Your Computer”)
FIGURE 3.
Ethernet Cable Connection
To connect the USB cable, follow the procedure according to your Operating
System:
WINDOWS
1.
Connect one end of the USB cable into the USB port of your PC
2.
Browse till
x:\USB driver
folder (where “
x
” is the CD-ROM drive unit letter);
launch the “
setup.exe
” executable (“
x:\USB driver\setup.exe
”) and follow
setup instructions