17
PRA-BD11 / PRA-BD12
En
English
14. Install the input terminal cover (or output terminal cover) on the rear panel.
÷
Secure the input terminal cover (or output terminal cover) supplied with the unit to
the DVD recorder rear panel using the black screws removed in Step 2. First tighten
screw
1
and then screw
2
.
Note:
Install the input terminal cover on the left expansion slot (as seen from the rear) (see the
section “Name of Parts” in the DVD recorder Operating Instructions). The output terminal
cover is installed in the right expansion slot (as seen from the rear).
1
2
Expansion slots on the
rear of the DVD recorder
Input terminal cover (or output terminal cover)
Installation
15. Reinstall the top panel (PRV-LX1).
÷
Use the seven screws removed in
Step 1.
Note:
Check that the FFC cables and the 4-pin
cables are connected to the PRA-BD11
input board and the PRA-BD12 output
board before installing the top panel.
Top panel
Cover panel
÷
Reinstall using the nineteen screws
removed in step 1. Fasten the screws
in the specific order
a
-
b
on the rear
surface, followed by the seven
screws in the top side, four on the
right side, four on the left side, and
the final two on the rear surface.
Note:
Check that the FFC cables and the 4-pin
cables are connected to the PRA-BD11
input board and the PRA-BD12 output
board before installing the top panel.
15. Reinstall the cover panel (PRV-LX10).