13
PRA-BD11 / PRA-BD12
En
English
B
D
A
a
b
d
Installation
÷
Install the PRA-BD11 input board in
the left expansion slot (as seen from
the rear) (see the section “Name of
Parts” in the DVD recorder Operating
Instructions). The PRA-BD12 output
board is installed in the right
expansion slot (as seen from the rear).
9. Connect the PRA-BD11 input board and the PRA-BD12 output board to the DVD
recorder with the FFC and 4-pin cables.
Notes:
÷
The cables for connecting the PRA-BD11 input board and the PRA-BD12 output board
differ. Refer to the figures below to make sure that each cable is properly oriented and
connected to the correct connector.
÷
Watch out for sharp corners (on arms, for example, see Step 11) when connecting and
routing cables.
PRA-BD11 input board connections
÷
Connect the 4-pin cable (M) already connected to connector
A
to connector
a
.
Secure the 4-pin cable (M) with a cable clamp before routing it.
÷
Unlock connectors
b
and
d
by raising their stoppers.
÷
Insert the FFC cable (M) already connected to connector
B
in connector
b
and lock by
lowering the stopper. See figure and note below (*).
÷
Insert the FFC cable (L) already connected to connector
D
in connector
d
and lock by
lowering the stopper. See figure and note below (*).
Note:
Connect the FFC cable to the unit with the blue reinforced side facing up.
PRA-BD11 input board or
PRA-BD12 output board
Place the label
side facing up
Expansion slot on the
rear of the DVD recorder
7. Install this unit in the rear panel of the DVD recorder.
÷
Fit the two projections in this unit into the
two hooks in the DVD recorder and secure
the unit with the two supplied screws
(silver, no washers). First tighten screw
1
and then screw
2
.
PRA-BD11
input board
4-pin cable (M)
FFC cable (M)
FFC cable (L)
Cable clamp
1
2
Notes:
÷
Do not use screws removed in Step 2 or Step 4.
÷
Make sure that no cables routed in Step 5 are located
beneath the unit.
Blue reinforced side
(two lines)
Unlocked
Locked
*
Make sure that the two lines in the reinforcement
are not visible when the connector is locked. If
they are still visible, disconnect and connect the
FFC cable again.