16
PRA-BD11 / PRA-BD12
En
Installation
12. Use the two screws (with washers) supplied with the PRA-BD11 input board
and the screw (with washer) supplied with the PRA-BD12 output board to secure
both boards to the rear bridge.
Rear bridge
PRA-BD12
output board
PRA-BD11 input board
13. Reinstall inner cover F and inner cover R (PRV-LX10 only).
÷
Insert the two hooking tabs on the inner cover R into the designated holes on the rear
panel of the DVD recorder, and reinstall the inner cover R as it was before step 3, then
fasten the inner cover R in place by first tightening the two type
5
screws in order
5
-
a,
5
-b, followed by the four type
4
screws.
÷
Insert the two tabs on the inner cover F into the two holes in the rear bridge, and
reinstall the inner cover F as it was before step 3, then insert and tighten the thirteen
mountain screws removed earlier (six type
1
screws (first insert two type
1
screws
in order
1
-a,
1
-b, then the remaining four type
1
screws), four type
2
screws and
three type
3
screws).
Note:
When reinstalling inner covers F and R, be careful that the gasket (see figure below) on
the DVD recorder side does not become detached.
Inner cover R
Insert the two hooking
tabs into the holes in
the rear panel
Rear panel of DVD recorder
Inner cover F
Inner cover R
-b
-b
-a
-a
Rear bridge
Gasket (located on
opposite side also)
Insert two tabs on inner
cover F into the two slots on
rear bridge
Cable clamps
When installing the
rear bridge, rotate
the cable clamps so
that they do not
strike the cushion
affixed to the lower
surface of the rear
bridge.
*