37
PRA-BD11 / PRA-BD12
Fr
Fran
ç
ais
f
Installation
11. Installez l’unité de noyau dans l’enregistreur DVD.
÷
L’unité de noyau est un composant réservé à la
carte de sortie PRA-BD12. Pour installer la carte
d’entrée PRA-BD11, passer à l’Étape 11.
1
Faites passer le câble FFC (L) par
l’ouverture du noyau. Installez le noyau
sur le pont arrière au moyen du rivet de
nylon fourni, en procédant comme
indiqué sur la figure de droite. Immobilisez
ensuite l’unité de noyau au moyen de la
vis (vis à rondelle).
Remarques :
÷
Enfoncez le rivet de nylon jusqu’à ce
que sa tête soit à ras de la surface.
÷
Lors de l’installation du noyau, faites
attention aux bords tranchants (sur les
bras et le pont arrière, par exemple).
Vis à
rondelle
Rivet de nylon
Ouverture
de noyau
Unité de
noyau
Pont arrière
Surface de contact
(Voir l’Étape 4)
Câble FFC (L)
Carte de sortie PRA-BD12
2
Débloquez le connecteur
f
.
3
Cheminez le câble FFC (L) par l’ouverture du
noyau, insérez le câble dans le connecteur
f
et immobilisez-le en abaissant la butée. Voir
la figure et la remarque ci-dessous (*).
Remarque :
Lors du branchement et du cheminement du câble
FFC (L), faites attention aux bords tranchants (sur
les bras et le pont arrière, par exemple).
Cavité du
bras
Noyau
Câble FFC (L)
Unité de noyau
Câble FFC (L)
Carte de sortie PRA-BD12
Remarque :
Pour éviter d’exercer une pression sur le câble FFC
(L) lors de l’installation de l’unité de noyau, placez
le noyau à côté de la cavité du bras, puis tenez le
noyau à un angle (illustré sur la figure) pour
cheminer le câble FFC aussi près que possible du
connecteur
f
.
Enfoncez le rivet
de nylon jusqu’à
ce que sa tête soit
à ras de la surface.
Côté renforcé bleu
(deux lignes)
Débloqué
Bloqué
*
Faites en sorte que les deux lignes du renforcement ne
soient pas visibles lorsque le connecteur est bloqué. Si
mêm une des deux lignes reste visible, débranchez et
branchez à nouveau le câble FFC.