Messages and how to react to them
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message
Cause
Action (Reference)
Route calculation was not
possible.
Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware.
!
Change the destination.
!
Consult the Pioneer Local dealer if this mes-
sage persists.
Route calculation not possi-
ble: destination is too far.
The destination is too far.
Set a destination closer to the starting point.
Route calculation not possi-
ble: destination is too close.
The destination is too close.
Set a destination farther from the starting
point.
Route calculation not possi-
ble: navigation cannot be pro-
vided around destination or
starting point.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
!
Set a destination and waypoint(s) on roads.
!
Reset the destination after you drive the ve-
hicle to any road.
Route to destination cannot
be calculated.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
Change the destination.
Failed to make the route pro-
file.
In rare cases, a route calculation
error may occur.
!
Retry.
!
Consult the Pioneer Local dealer if this mes-
sage persists.
No picture folder. Save jpeg
file to /Pictures/ folder
Cannot load the image because
“
Pictures
”
folder is not found in the
inserted external storage device.
Use appropriate data and store it correctly.
(Page 143)
“
Pictures
”
folder exists on the SD
memory card but there is no load-
able data in the folder.
Use appropriate data and store it correctly.
(Page 143)
Data Read error.
Failed to read the data for some rea-
son.
Use appropriate data and store it correctly.
(Page 143)
The file is corrupt
The data is damaged or an attempt
was made to set an image file that
was not made to specifications as
the splash screen.
Use appropriate data and store it correctly.
(Page 143)
Engb
176
Appendix
Appendix
