43
TSP-16
5
6
7
8
5
6
7
8
A
B
C
D
E
F
PAGE
6 : ENCODER TEST
PU
S
H ENCODER
PU
S
H ENCODER
S
TATU
S
: [ON, OFF]
6 ENCODER (1)
:
0
6 ENCODER (2)
:
0
6 ENCODER (
3
)
:
0
6 ENCODER (4)
:
0
6 ENCODER (5)
:
0
6 ENCODER (6)
:
0
•
Mode for confirmation of the Encoders
•
PU
S
H ENCODER also displays the status when
it is pushed.
When it is pushed, "ON" is displayed. When it is
not pushed, "OFF" is displayed.
[PAGE 6] ENCODER TEST
PU
S
H
ENCODER
ENCODER(1)
ENCODER(6)
PAGE
7 : TOUCH PANEL TEST
Touch dots
•
Check using a touch pen with small tip is recommended
•
Mode for checking the accuracy of touch point.
•
If you touch squares at four corners shown above, they will become blue.
If you touch all squares, check result will become OK.
•
If you press REC button, mode will shift to the calibration mode.
While touching the center of + mark of red square in the upper left, press REC button.
While touching the center of + mark of red square in the upper right, press REC button.
While touching the center of + mark of red square in the lower left, press REC button.
While touching the center of + mark of red square in the lower right, press REC button. Calibration will be completed.
(If the calibration is completed by pressing REC button without touching it, calibration value will be discarded.
Touch motion will be operated without calibration.)
[PAGE 7] TOUCH PANEL TEST
:
*
Calibration of the touch panel, carried out only at the time of check NG.
