55
TSP-16
5
6
7
8
5
6
7
8
A
B
C
D
E
F
Front
Front
Front
• Rear view
2
3
1
1
1
CN9200
2
3
4
4
5
5
5
5
5
6
x 11
:
7
S
TBY A
SS
Y (side-A)
Chassis
Nut and
Washer
S
TBY A
SS
Y
MVR A
SS
Y
MVR A
SS
Y
IO A
SS
Y
IO A
SS
Y
MAIN A
SS
Y
x 11
Chassis
Nut
CN6
8
00
CN5000
CN5001
S
tay (DNF19
8
9)
S
tay (DNF19
8
9)
∗
11
∗
12
[2-4-7] STBY ASSY
Remove the two screws. (BPZ30P0
8
0FNI)
Reverse the
S
TBY A
SS
Y.
Disconnect the connector and then remove
the
S
TBY A
SS
Y.
[2-5] Chassis Section
Remove the Exterior
S
ection.
(Refer to the
“[2-1] Exterior Section”
)
-----------------------------------------------------------------
[2-5-1] MVR ASSY,
IO ASSY
Remove the two screws. (BBZ30P060FTB)
Note on assembling
∗
11: These two screws must be attached after
snap-fitting the Chassis
S
ection to the
Panel
S
ection.
Disconnect the connector and then remove
the MVR A
SS
Y (with the
S
tay).
Remove the nut and washer (accessory of
VR), and then remove the
S
tay (DNF19
8
9)
from the MVR A
SS
Y.
Disconnect the two connectors.
Remove the five screws. (BBZ30P060FTB)
Note on assembling
∗
12:
S
crews must be attached so as to leave a
gap of about 0.5 mm between the IO A
SS
Y
and MAIN A
SS
Y.
Remove the 11 nuts. (NKX2FNI)
Note:
Take care not to damage the screw thread of
the Jack.
Remove the IO A
SS
Y.
