Phytec phyCORE-i.MX 6, Руководство по оборудованию

Страница: 16 / 82

phyCORE
®
-i.MX 6 [PCM-058]
2 ©
PHYTEC Messtechnik GmbH 2016 L-808e_2
•
Controller signals and ports extend to two high-density (0.5 mm) Samtec connectors
aligning two sides of the board, enabling the phyCORE-i.MX 6 to be plugged like a "big
chip" into target application
•
Single supply voltage of +3.3 V with on-board power management
•
All controller required supplies are generated on board
•
Improved interference safety achieved through multi-layer PCB technology and
dedicated ground pins
•
512 MB (up to 2 GB
2
) DDR3 SDRAM
•
256 MB (up to 16 GB
2
) on-board NAND Flash
•
Alternatively 2 GB (up to 32 GB
2
) on-board eMMC
•
16 MB
2
on-board serial Flash (bootable)
•
4 kB
2
I
2
C EEPROM
•
Two serial interfaces (TTL). One with 4 lines allowing simple hardware handshake
•
High-Speed USB OTG interface
•
High-Speed USB HOST interface
•
10/100/1000 Mbit Ethernet interface
.
Either with Ethernet transceiver on the
phyCORE-i.MX 6 allowing for direct connection to an existing Ethernet network, or
without on-board transceiver and provision of the RMII signals at TTL-level at the
phyCORE-Connector instead
3
•
I
2
C interface
•
Two SPI interfaces
•
PCIe interface
•
I
2
S interface
•
SPDIF interface
•
PWM output
•
CAN interface
•
Two 4 channel LVDS (24 bit) LCD-interfaces
•
Parallel LCD-interface with up to 24-bit
•
HDMI interface
•
Up to two parallel camera interfaces
•
MIPI CSI camera interface
•
Two SD/MMC card interfaces (1 x 8 bit, 1 x 4 bit)
•
SATA interface
•
JTAG interface
•
One user programmable LED
•
Several dedicated GPIOs
4
•
Power Management IC (PMIC)
•
Available for different temperature grades ( section 17.1 )
2
:
The maximum memory size listed is as of the printing of this manual. Please contact PHYTEC for more information about additional, or
new module configurations available.
3
:
Please refer to the order options described in the Preface, or contact PHYTEC for more information about additional module confi-
gurations.
4
:
Almost every controller port which connects directly to the phyCORE-Connector may be used as GPIO by using the i.MX 6's pin muxing
options.