Phoenix Contact IB IL 24 PSDO 8-PAC, Руководство пользователя, Страница: 85 / 112

Technical data and ordering data
7619_en_05 PHOENIX CONTACT
85 / 112
Surge protection Yes (in the bus coupler / power terminal)
Protection against polarity reversal Yes (in the bus coupler / power terminal)
Undervoltage detection Yes, at approx. 17 V
Diagnostics indicators Green U
M
LED
(see “Local diagnostic and status indicators” on page 23)
External protection 8 A slow-blow, maximum
Supply voltage: U
M
(actuators) (Fortsetzung)
NOTE: Module damage due to polarity reversal
Polarity reversal places a burden on the electronics and, despite protection against polarity reversal, can dam-
age the module. Therefore, polarity reversal must be prevented.
NOTE: Module damaged when overloaded
The power supply unit must be able to supply four times (400%) the nominal current of the external fuse.
Safe digital outputs OUT0 to OUT3
Number 4 two-channel or 8 single-channel (positive switching)
Supply From supply voltage U
M
Maximum output current per output 2 A
Maximum output current for all outputs (total current) 6 A (observe derating and maximum output current for each
group)
Maximum output current for each group (total current)
Group 1 (OUT0_K1, OUT1_K1, OUT2_K1, OUT3_K1) 3 A
Group 2 (OUT0_K2, OUT1_K2, OUT2_K2, OUT3_K2) 3 A
Maximum output voltage in the low state < 5 V
Maximum leakage current in the low state 2 mA
Minimal non-release voltage of the connected loads > 5 V
Maximum inductive load 1 H
WARNING: Loss of safety function
At this voltage, the load must not switch and not remain in the switched on condition! Please take this into con-
sideration when selecting the actuator.
WARNING: Loss of safety function
At this current, the load must not switch and not remain in the switched on condition! Please take this into con-
sideration when selecting the actuator.