Phoenix Contact IB IL 24 PSDO 8-PAC, Руководство пользователя, Страница: 23 / 112

Product description
7619_en_05 PHOENIX CONTACT
23 / 112
2.6 Local diagnostic and status indicators
Figure 2-3 Local diagnostic and status indicators on the IB IL 24 PSDO 8-PAC module
1 2
PS
DO
8
0
1 2
1
1 2
2
1 2
3
D
FS
UM
500KBD
2MBD
Mode2
Mode1
76191003
D
PSDO8
1
2
1
2
1
2
1
2
FS
UM
0 1
2
3
9
87
65
43
21
0
P
P
Table 2-1 Local diagnostic and status indicators
D Green LED Diagnostics
Off: Communications power not present
Flashing at
0.5 Hz:
Communications power present, local bus not active
Flashing at 4 Hz: Communications power present, error at the interface between previous and flashing
terminal (the terminals after the flashing terminal cannot be addressed).
(For example, loose contact at the bus interface, terminal before the flashing terminal
has failed, another terminal was snapped on during operation (not permitted))
On: Communications power present, local bus active
FS Red LED Failure state
Flashing at 1 Hz: Device not parameterized or parameterization was not accepted
On: Hardware fault
Communication to safe controller disabled and output driver enable reset.
Observe the module startup time of approximately 16 s. During this time the D LED flashes at
4 Hz and the bus cannot be started up.