Philips Divar, Руководство по установке

Страница: 54 / 74

Menu system
5-14 Philips Communication, Security & Imaging
>>> Output handling
• Select the profile for which you wish to configure the output
handling.
• Select the number of the output relays to be activated when an
enabled event in the selected profile is activated.
• Enable the beeper to activate it when an enabled event in the
selected profile is activated.
>>> Recording setup
• Recording behavior for each of the six profiles is specified in three
submenus. The
Normal
submenu is for a normal situation without
alarms or motion events. The
Input
submenu is for input changes.
The
Motion
submenu is for motion events.
• The list gives an overview of inputs and motions that are used in any
of the profiles. A check mark means used.
Normal
• Select the profile. The
Unallocated IPS
item shows the IPS
capacity remaining.
• A total of 60 images per second (IPS) can be recorded for NTSC; 50
IPS for PAL. A minimum of 1 IPS is always allocated per camera for
pre-alarm recording and network viewing.
• Set the recording rates and quality levels for each camera. Quality is
standard, medium or high.
• IPS rates for PAL range from Never, 0, 1/10 (one image every 10
seconds), up to 25 IPS.
• IPS rates for NTSC range from Never, 0, 1/10 (one image every 10
seconds), up to 30 IPS.
• Set the recording speed to NEVER to not record a camera at all. No
pre-alarm recording is done and the camera cannot be viewed over
the network.
Input
• Each input, when activated, can change the normal recording
behavior of up to four cameras for a maximum of 120 seconds.
• Select the profile. Select the input number.
• Select the cameras whose recording behavior should change. Set the
recording rates and quality levels for each camera. Set camera name
to
None
to use less than four cameras.
• To free IPS bandwidth, the recording rate of cameras not in alarm is
limited to the IPS number displayed.
Motion
• Each motion input, when activated, can change the normal
recording behavior of up to four cameras for a maximum of 120
seconds.
• Select the profile. Select the motion camera number.
• Select the cameras whose recording behavior should change. Set the
recording rates and quality levels for each camera. Set camera name
to
None
to use less than four cameras.
• To free IPS bandwidth, the recording rate of cameras not in alarm is
limited to the IPS number displayed.
>>> Access restrictions
• Remote access restrictions can be set for each of the six profiles.
Remote user 1, the administrator, always has access.
• Select the profile. Select if remote playback can be enabled or not
for remote users.
• Select which remote users have access and which are blocked.
>>> Copy system behavior
• To copy the settings of one profile to another, enter the number of
the source profile, enter the number of the destination profile and
select the
Copy Now
item.