Phase AxM II 04.09.4, Руководство пользователя

Страница: 74 / 84

76 | Axm ii / AxP Configurable Motion Control Platform
tion and maintenance are prerequisites for optimal and safe operation of this device.
» Only assign trained and qualified persons to work with electrical installations:
Only persons who are trained and qualified for the use and operation of the device
may work on this device or within its proximity. The persons are qualified if they have
sufficient knowledge of the assembly, installation and operation of the equipment as
well as an understanding of all warnings and precautionary measures noted in these
instructions.
Furthermore, they must be trained, instructed and qualified to switch electrical cir-
cuits and devices on and off in accordance with technical safety regulations, to
ground them and to mark them according to the requirements of safe work practices.
They must have adequate safety equipment and be trained in first aid.
»
Only use spare parts and accessories approved by the manufacturer.
»
Follow all safety regulations and requirements for the specific application as practiced
in the country of use.
»
The devices have been designed for installation in industrial machinery.
»
The ambient conditions given in the product documentation must be observed.
»
Only use safety-relevant applications that are clearly and explicitly approved in the Proj-
ect Planning Manual. If this is not the case, they are excluded. Safety-relevant are all
such applications which can cause danger to persons and material damage.
»
The information given in the documentation of the product with regard to the use of the
delivered components contains only examples of applications and suggestions.
The machine and installation manufacturer must make sure that the delivered com-
ponents are suited for his individual application and check the information given in
this documentation with regard to the use of the components, make sure that his ap-
plication complies with the applicable safety regulations and standards and carry out
the required measures, modifications and complements.
»
Startup of the delivered components is only permitted once it is sure that the machine
or installation in which they are installed complies with the national regulations, safety
specifications and standards of the application.
»
Operation is only permitted if the national EMC regulations for the application are met.
»
The instructions for installation in accordance with EMC requirements can be found in
the documentation “EMC in Drive and Control Systems”.
»
The machine or installation manufacturer is responsible for compliance with the limiting
values as prescribed in the national regulations.
»
Technical data, connections and operational conditions are specified in the product doc-
umentation and must be followed at all times.
Explanation of Warning Symbols and Degrees of Hazard Seriousness
The safety instructions describe the following degrees of hazard seriousness. The degree of
hazard seriousness informs about the consequences resulting from non-compliance with the
safety instructions:
Warning symbol with signal word Degree of hazard seriousness according to ANSI Z 535
Death or severe bodily harm will occur.
Death or severe bodily harm may occur.
Bodily harm or material damage may occur.
DANGER
WARNING
CAUTION
AxM-II (2011-10).indd 76 18/10/11 15:15