Adjustment
86
Fig. 13 - 25
108-131
4
1
3
2
5 mm
13
.27
Adjusting the lifting lever of the end knotting equipment
Requirement
When parameter "610" is set at "1" and the machine is in the needle rise position, the
retaining finger
1
should be positioned
5 mm
behind the centre of the needle and the
lifting lever
4
should be touching screw
2
.
●
Switch on the machine, set parameter "610" at "1" and bring the needle bar into the
needle rise position.
●
Disconnect the machine from the pneumatic power supply.
●
Position the retaining finger
1
by hand.
●
Turn screw
2
(nut
3
) in accordance with the
requirement.
●
Switch off the machine.
Make sure that the retaining finger
1
does not touch the loop spreader.
Содержание 3307-1 SERIES
