PERCo TTR-07.1, Руководство по сборке и эксплуатации

Страница: 9 / 34

Assembly and Operation Manual
Figure 3. RC panel overall view
1, 2, 3 – buttons LEFT , RIGHT , STOP for setting the passage mode;
4, 5 – green indicators «Left» , «Right» ;
6 – red indicator «Stop», 7 – RC cable.
There are three control buttons on the RC front panel intended for setting the turnstile
operating modes. The LED indicators are located above the buttons. The middle button on
the RC panel (hereinafter — the
STOP button) is intended to set the turnstile to the
“Always locked” mode. The left ( LEFT ) and the right ( RIGHT ) buttons are intended to
unlock the turnstile for passage in the chosen direction.
The RC panel is connected to the CLB with a multicore cable
(12) via the “XT1.L” connector
block (See Fig. 4 and Fig.11).
If the turnstile orientation relatively to the operator’s terminal is not standard (e.g. the
terminal is placed at the backside of the turnstile housing), the RC panel orientation
towards the turnstile can be changed by exchanging places of the RC wires to the contacts
“Unlock A” and “Unlock B” as well as contacts “Led A” and “Led B” accordingly (see Fig. 4
and Fig. 11).
5.2.5 The CLB (Fig. 4) includes:

X1
(
LED
),
X2
(
SENS
),
X3
(
MOTOR
) connectors to connect the indication module,
optical arm rotation sensors and control mechanism with a locking device (from the
X1, X2, X3 connectors with the turnstile cable);

XT1.L
(
In
) connector block to connect the RC panel / the WRC / ACS controller (11)
inputs as well as an emergency unblocking device ( Fire Alarm) (9) and intrusion
detector;

XT1.H
(
Out
) connector block to connect a siren and ACS outputs, providing the
turnstile status data to the ACS controller;

XT3
(
+12VDC
) connector block to connect the turnstile power supply;

XT4
(
Light A
) and
XT5
(
Light B
) connector blocks to connect “open/closed” remote
indicators, one indicator per each direction;
8