PERCo TTR-07.1, Руководство по сборке и эксплуатации

Страница: 27 / 34

Assembly and Operation Manual
10 MAINTENANCE
The turnstile housing maintenance is required once a year or in case of some technical
failures. The maintenance should be carried out by qualified mechanic only.
Note:
Prior to the turnstile maintenance works disconnect the turnstile power supply from
the AC mains.
Maintenance is carried out in the following order:
1. Remove the cover with LED indication display (2) from the turnstile housing.
2. Check visually the resetting device (pusher, springs and roller), the arm rotation
sensors and the damper (Fig. 12).
3. Remove dust from the arm rotation sensor disc, located in the spacing of the arm
rotation optical sensors, with alcohol-gasoline blend applied with a cloth. Avoid the
ingress of dust on the operational spacing of the both arm rotation optical sensors.
4. Lubricate the friction units of the resetting device with the machine oil (see Fig. 12):
a. resetting mechanism pusher lever;
b. stop spring fastening axis;
c. stopper rotation axis.
Note:
Avoid the ingress of lubricant on the arm rotation sensor disc and the roller
surfaces.
5. Check the reliability of the cable connections to the CLB connector blocks
ling. When the cover mounting is carried out correctly it does not need much
ing
y turnstile
ousing fastening to the floor and if necessary,
f the holes in the turnstile housing (1) base;
isual check please apply to the PERCo Technical
Support Department (the PERCo TSD).
and if necessary tighten the cable fixing screws.
6. Connect the cable header of the indication board to the control mechanism connector
and mount the cover with LED display (2) back into its place in the reverse order to the
dismant
effort.
7. Check the reliability of the barrier arm
(5) fasten
8. Check the reliability of hub fastening bolts (4).
9. Check the reliability of electromechanical barrier arm unblocking device b
power on / off. If necessary lubricate the hinged connections to the hub (3).
10. Check the reliability of the turnstile h
tighten the anchor bolts (13). To do that:

remove plastic plugs (14) out o

tighten the anchor bolts (13);

put the plastic plugs (14) into their places.
In case of any defects revealed during v
26