27830 -3/40-
TY-CNL-D 1.7x3.0Ni
A161
BT(10x30)
Blue
Brown
Green
Black (0-Q100)
T94
BT(10x30)
TY-CNL-E 2.0x7.0
DT(25x50)
DT(5x25)
DT(3x15)
TY-CNS 1.7x4.5
A150
A154
A152
A153
(A185)
A151
A7
A8
TY-CNL-D
1.7x3.5Ni
W3(t=0.15)
A160
TY-CNL-D
1.7x3.5Ni
6
）
Discharge electricity of the main capacitor.
-1. Peel off the BT (10x30) from the flash PCB.
-2. Discharge electricity of the main capacitor with
a resistor of 100
Ω
-1k
Ω
.
Land of the blue lead wire (29 Xe+) on 0-Q2000
Hot shoe (A322) or Battery contact: Minus side (A34)
Fig.4
Fig.5
1-2. Side Cover (A161)
TY-CNL-D1.7x3.0Ni (x2)
Fig.6
1-3. Grip (A150)
1
）
A151
2
）
2 screws (TY-CNL-E 2.0x7.0, TY-CNS 1.7x4.5)
[NOTE] A185 has already been removed at step 1-1-(2)).
3
）
A150, A8, A7
Fig.7
1-4. Front Cover (A160)
1
）
Set the Focus mode switch at [AF.S].
2
）
TY-CNL-D1.7x3.5Ni (x5)
W3 (t=0.15, x2)
3
）
Remove A160 while lifting up the release
socket side of front cover.
Fig.8
1-5. Top Cover (0-A301)
1
）
4 lead wires (0-Q200)
Fig.9
Fig.10 Fig.11
[Note of Assembly]
Remove the TY-CNL-F1.4x4.0 that has been installed
temporarily, and then install the temporary bottom
cover and battery cover.
Step to final adjustments and confirmation (p.27).
[Note of Assembly]
The lead wires on the flash PCB should be arranged in good order to prevent pinch by
the motor or electronic parts as shown in Fig.10.
Stick T94 (10x13) and BT (10x30) as shown in Fig.11.
