27830 -13/40-
G-151
T71
L2
M4
M10
B6
0-B8
B7
B5
B10
4-5. 0-G100
[NOTE] Make sure that the mirror sheet should be placed at top end position.
1) Latch the lever (B) while pushing down the sliding
plate (A) as shown in Fig.64.
2) 4 screws, 0-G100
3) Remove B7 while pushing down the spring (0-B9).
4
）
Remove 0-B8 while moving the lever (B11) to upward.
5
）
Remove other levers and springs.
Fig.64
Fig.65
Fig.66
Fig.67
Fig.68
4-6. L2
1
）
Move the hooking part of M10 front upward while holding
M4 gently, so that M4 drops down.
2
）
L2
3
）
Remove M22 and L23 while moving the hooking plate to
frontward as shown in Fig.69.
[NOTE] When handling the L23, hold it by the place indicated
by the arrow in Fig.69 to prevent a scratch.
Fig.69
TY-CNL-D1.7x3.0
TY-CNL-D1.7
×
3.5
TY-CSS1.7x3.0
B
A
[Note of Assembly]
1. Apply G126 to each shafts (7 places) and the
place indicated by (C) in Fig.65.
2. Hold 1
st
mirror sheet at top end position by
finger, and then install B7, B6 and 0-B8
while positioning as shown in Fig.66.
3. Apply G151 to the code plate of T71.
4. Install 0-G100 to the Front housing block
while keeping latched condition.
C
B11
0-B9
