27830 -11/40-
0-S300
Black
Red
TY-CNL-D1.7x8.0
0-Q200
Charge-side
Rewind-side
①
②
■
planet gear arm assy.
3-2. [CONF.] Function Check of Mirror Charging and Rewinding
1
）
[CONF.] Make sure that the planet gear arm assy should be placed at charge side as shown
in Fig.54.
2
）
[CONF.] Apply DC4V to 0-S250 with care taken to polarity
of motor, and then confirm the function of mirror sheet
and charging.
3) Set the planet gear arm assy at rewind side.
4) [CONF.] Apply DC4V to 0-S250 as reverse polarity,
and then confirm the function of rewinding.
5) Set the planet gear arm assy at charge side, and then
set the mirror sheet to mirror-down condition while
rotating B103 anticlockwise.
Fig.54
3-3. [ADJ./CONF.] Mechanical Back
1
）
[CONF.] Confirm the mechanical back.
2
）
[ADJ.] Remove A104 and A118, and then adjust the mechanical
back by replacing W98 (x5).
3
）
Tighten A119 (x5) in the numerical order (
①
,
②
,
･･
,
⑤
) as shown
in Fig.55, and then confirm the mechanical back again.
Fig.55
3-4. [ADJ./CONF.] AF Joint Stroke
[Required equipment] Vernier calipers
1) Set the AF mode SW at AF.S. (Down position)
2) [CONF.-1] AF coupler of 0-S300 should project from the mount surface by 1.2 mm or more.
3) [CONF.-2] When the mount lock lever is depressed and the mount lock pin comes to mount
surface, the AF coupler should not project out of mount surface.
4) [ADJ.] Turn an eccentric screw on the mount lock lever to adjust, and apply the screw-lock
agent to the screw.
3-5. 0-Q200
1
）
Arrange the lead wires of 0-S300 as shown in Fig.56.
2
）
0-Q200, 1 screw
3
）
2 lead wires (Red, Black)
Fig.57
3-6. A141
Fig.56
1
）
Install A141 with arranging the lead wires.
2
）
M12
Fig.58
A141
TY-CNL-D
1.7x3.0
M12
DC4V
：
Charge
・・・（＋）（−）
DC4V
：
Rewind
・・・（−）（＋）
Standard: 45.46 mm
Tolerance:
±
0.04
A119
③
①
②
④
⑤
