27830 -10/40-
Black
Red
TY-CNL-D1.7x3.0
0-Q200
TY-CNL-D1.7x4.0
TY-CNL-D
1.7x4.0
TY-CNL-D
1.7x5.5
B103
0-B102
TY-CNL-E
2.0x5.5
①
②
③
④
W14 (0.1)
W14 (0.05)
A141
TY-CNL-D1.7x3.0
M12
3. MAIN BODY AND FRONT HOUSING BLOCK
[Disassembly Procedures]
3-1. A141
1) TY-CNL-D1.7x3.0 (x2)
2) A141
3) M12
3-2. 0-Q200
1) 2 lead wires (Red, Black)
2) TY-CNL-D1.7x3.0
Fig.45 Fig.46
3-3. Main Body and Front Housing Block
1
）
TY-CNL-D1.4x3.0, Battery cover SW (A36
･
A37
･
A38)
2
）
Set the mirror sheet to mirror-up condition.
[NOTE] Set the mirror sheet and sliding plate at top end position and stroke while rotating
B103 anticlockwise by using finger.
[CAUTION] Do not rotate B103 reverse-wise to prevent damage.
3
）
TY-CNL-D1.7x4.0 (Bottom of the film chamber)
4
）
TY-CNL-D1.7x4.0, TY-CNL-D1.7x5.5 (0-B102)
5
）
TY-CNL-E2.0x5.5 (x4)
Fig.47
Fig.50
Fig.48
[Assembly Procedures]
Fig.49
3-1. Main Body and Front Housing Block
1
）
[CONF.] Make sure that four W14’s (0.05, 0.1) are bonded on the Main body.
2
）
Set the Front housing block to mirror-up condition. (The mirror sheet, sliding plate and
shutter charge lever should be placed at top end position and stroke as shown in Fig.52.)
3
）
Distribute 2 solenoid wires upward, and lower lead wires to downward as shown in Fig.51.
4
）
Install the Front housing block to the Main body, using care that the flexible boards and
lead wires are not pinched in between them.
5
）
Tighten 4 screws in the numerical order (
①
,
②
,
③
,
④
) as shown in Fig48.
6
）
Tighten 3 screws as shown in Fig.49, 50.
7
）
Battery cover SW (A36, A37, A38), TY-CNL-D1.4x3.0
Fig.53
Fig.51 Fig52
