27830 -4/40-
TY-CNS1.7x7.0Ni
TY-CNL-D
1.7x8.0
TY-CNL-D
1.7x5.0
TY-CNL-D1.7x4.0Ni
T51
＊
Unsolder
(Main SW)
Blue
Brown
Green
Black
BT(6x10)
0-T200
DT(7x5)
2
）
Disconnect a connector of 0-T200.
3
）
BT (6x10) x2
Fig.12
4) 5 Screws (Refer to Fig.13 and 15)
5) Lift up the rear side of 0-A301 with care to prevent damage to flexible board is inside cover.
Fig.13
Fig.14
Fig.15
6) M311, M312
Fig.16
7
）
14 lands on T51
Fig.17
8) TY-CNL-B1.4x2.0
9) T94
10) 10 lands on T57
11) 7 lands on T21 of 0-A332
Fig.18
T57
TY-CNL-B1.4x2.0
T21
T94
3mm
[Note of Assembly]
The 4 lead wires of 0-A301 should be arranged
as shown in Fig.12.
The slack of lead wires should be arranged
between 0-Q200 and Main body.
[Note of Assembly]
Preparation of installing 0-A301:
Set 0-C17 (Cam gear assy) at the position where
the cam portion of 0-C17 cannot be seen as
shown in Fig.14.
Set the diopter adjustment dial as shown in
Fig.15, and then install 0-A301 to the body.
[Note of Assembly]
Unsolder on the Main SW lands of
0-T100 (
＊
Unsolder) as shown Fig.17.
