Penlon Prima 320 Advance, Руководство пользователя

Страница: 66 / 96

Prima 320 Advance 60 User Manual
6.5 Monitoring Parameters
6.5.1 FiO2 monitoring
If the system is configured with an O2 module or an oxygen
sensor, FiO2 values are displayed.
CAUTION
If an O2 sensor is used, calibrate the sensor when the
measured value of O2 concentration is outside specification
range, or when a new sensor is fitted. Refer to section 7.8.
6.5.2 CO2 monitoring
If the system is fitted with a CO2 module, you can monitor FiCO2
and EtCO2 by setting the CO2 module for open state.
6.5.3 Pressure monitoring
Pressure related parameters are listed below.
PEEP
Ppeak
Pplat
Pmean
6.5.4 Tidal volume monitoring
CAUTION
The tidal volume values on the bellows housing give an
approximate indication, and may be inconsistent with the
actual measured volumes. This is a normal phenomenon.
International standards require that the user must monitor
tidal volume during a clinical procedure.
Volume related parameters are measured as shown below.
VTI
VTE
MV
MVspn
6.5.5 Breath rate monitoring
Breath rate related parameters are measured as shown below.
ftotal (total respiratory rate)
fspn (spontaneous respiratory rate)
6.6 Pulmonary Function
The system displays dynamic compliance monitoring, static
resistance, and spirometry loops to reflect the patient’s
pulmonary function.
The system provides two spirometry loops: Paw-V (Paw-
volume) loop and V-Flow (volume-flow) loop.
The scales of volume flow and Paw are adjusted automatically.
Paw-V loop and V-Flow loop are shown in section 6.2.5.
Operating the Anaesthesia System