PELLA
®
INSYNCTIVE
®
INTEGRATED ENTRY DOOR SENSOR PRODUCT GUIDE
|
18
3. Prepare LOCK SENSOR
Remove lock transmitter from door and lift up a corner of the
clear plastic cover to expose the battery. Remove and reinsert the
battery to place LOCK SENSOR in deletion mode for 2 minutes.
NOTE:
If 2 minutes pass without a successful deletion, remove
and insert the battery again.
Insert the lock transmitter back into your entry door, close and
lock the door, then wait 10 seconds.
The lock transmitter has now learned what type of door it is
housed in. You are ready to delete LOCK SENSOR from BRIDGE.
4. Delete LOCK SENSOR from BRIDGE
WITHOUT HOME AUTOMATION (Stand-Alone Mode)
Press and hold BRIDGE Sync button until light begins flashing
orange. The Sync button is the bottom button located on the side
of BRIDGE.
NOTE:
BRIDGE is in sync mode while the orange light is flashing.
BRIDGE will remain in sync mode for 2 minutes. BRIDGE will then
beep, and orange light will turn off to indicate BRIDGE exited
sync mode.
To delete LOCK SENSOR from BRIDGE, lock then unlock your
entry door; repeat 2 times within 5 seconds.
Wait for the light on BRIDGE to flash red and beep 3 times. This
will indicate a successful deletion.
If LOCK SENSOR deletion is unsuccessful, return to Step 3 and
retry the process.
Repeat the above steps until all INTEGRATED ENTRY DOOR
SENSORS have been deleted from BRIDGE.
To exit sync mode, press and hold Sync button on BRIDGE until
light stops flashing orange.
WITH HOME AUTOMATION
BRIDGE supports two types of home automation system
Professionally Installed and Do-it-Yourself (DIY) Z-Wave. For
a list of compatible home automation systems and deletion
instructions, visit
Insynctive.Pella.com
.
ADDITIONAL INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
BRIDGE
PLASTIC COVER
BATTERY
TAB
BATTERY TAB
REMOVED
UNLOCKED
LOCKED
LOCK
TRANSMITTER
