PELLA
®
INSYNCTIVE
®
INTEGRATED ENTRY DOOR SENSOR PRODUCT GUIDE
|
15
DELETING INTEGRATED SENSOR for Entry Door by Pella
with Deadbolt Lock
Deleting INTEGRATED ENTRY DOOR SENSORS may be needed
if you no longer have a use for INTEGRATED ENTRY DOOR
SENSORS. See
Insynctive.Pella.com/Support
for how-to-videos.
1. Prepare OPEN/CLOSE SENSOR
Use a small flathead screwdriver to remove the plastic endcap from
OPEN/CLOSE SENSOR. Grip the edges of the circuit board and pull
it out to gain access to the battery. Slide out the battery, then slide
it back in, then reinsert OPEN/CLOSE SENSOR into your entry door.
Install the plastic endcap back onto OPEN/CLOSE SENSOR.
NOTE:
Once the battery is removed, you will have 2 minutes to
delete your OPEN/CLOSE SENSOR from BRIDGE. If 2 minutes pass
without successful deletion, remove and insert the battery again.
You are ready to delete OPEN/CLOSE SENSOR from BRIDGE.
2. Delete OPEN/CLOSE SENSOR from BRIDGE
WITHOUT HOME AUTOMATION (Stand-Alone Mode)
Press and hold BRIDGE Sync button until light begins flashing
orange. The Sync button is the bottom button located on the side
of BRIDGE.
NOTE:
BRIDGE is in sync mode while the orange light is flashing.
BRIDGE will remain in sync mode for 2 minutes. BRIDGE will then
beep, and orange light will turn off to indicate BRIDGE exited
sync mode.
To delete OPEN/CLOSE SENSOR from BRIDGE, open then close
your entry door twice within 5 seconds.
Wait for the light on BRIDGE to flash red and beep 3 times. This will
indicate a successful deletion.
If OPEN/CLOSE SENSOR deletion is unsuccessful, return to Step 1
and retry the process.
ADDITIONAL INSTRUCTIONS
(continued)
LIGHT
SYNC
BUTTON
TEST
BUTTON
BRIDGE
BATTERY
DOOR
PANEL
PLASTIC
ENDCAP
OPEN/CLOSE
SENSOR
